LIMITED LIFETIME WARRANTY

Products manufactured by JBA are guaranteed to be free from defects in materials and workmanship at the time of sale, and are guaranteed to fit the intended application, provided the vehicle has not suffered structural damage or other modification*. Claims for damage occurring during shipment must be made to the carrier. JBA, at its option, will repair or replace any product found to be defective in materials or workmanship.

Failure of any JBA product while on the originally installed vehicle, will entitle the original purchaser to repair, replacement, or pro rata credit according to the following chart:

Certain uses or occurrences listed below will void this warranty.

PURCHASER ASSUMES RESPONSIBILITY: JBA expressly disclaims, and the purchaser expressly assumes, responsibility for all labor related costs and any incidental or consequential damages arising from any JBA product installation or failure. JBA’s liability is limited to the purchase price of the product. JBA, at its option, may refund the amount of the purchase to end a warranty claim. Labor charges incurred to install or remove the product are not covered. Damage resulting from incorrect timing, fuel system problems, clogged catalytic converters or backfire is not covered. Charges for the loss of use of vehicle, car rentals, and towing are the responsibility of the customer and are not covered. Cost of customer-applied coatings is not covered. As sound preference is subjective, sound is not warranted. Other than the warranty described herein, JBA products are sold “AS IS”. No warranty terms are implied. The terms of this warranty are severable. Any provision voided by state or other applicable law shall not act to enlarge other provisions of this warranty except as expressly required by law. Catalytic converters and other products sold but not manufactured by JBA are subject to the product manufacturer’s warranty only and are not warranted by JBA.

THE FOLLOWING WILL VOID THIS WARRANTY: Use of “ heat-wrap” products and/or the use of fuels other than gasoline will void this warranty. Damage caused by improper installation is not covered under this warranty. Damage caused by collision, road hazards, or failure of other components is not covered. Any repair or alteration to a JBA product not performed by JBA or its authorized agents will void this warranty.

NO FREIGHT WARRANTY: JBA does not warrant freight. The purchaser will be responsible for freight to and from JBA. Contact JBA to make a warranty claim and to receive a return authorization number. Return the product freight prepaid along with a copy of the original purchase invoice and a written description of the problem including the return authorization number to the address below. JBA does not accept freight-collect shipments. A product found to be defective or otherwise covered under this warranty will be repaired or replaced per the above policy and returned freight-collect.

JBA cannot assume responsibility for compliance with local law and regulations regarding smog and noise standards. Headers described as “smog legal” are warranted to be C.A.R.B. (California Air Resources Board) exempt or pending exemption approval. This warranty is extended solely to the original purchaser and for the original vehicle on which the product was installed.
 

JBA reserves the right to change the price, design, material, or specifications of any product without notice.

Automotive Engineered Products
dba JBA Headers and Performance Exhaust
7149 Mission Gorge Road
San Diego, California 92120

© Copyright 2005-2006 Automotive Engineered Products Inc. All rights reserved
* Note that certain custom headers may require different engine mounts or brackets for proper fit.